User manual

20
Event :
An Event begins when an object blocks the laser beam in
Trap Mode (or leaves it in Escape Mode). An Event ends when
the laser beam is not blocked anymore in Trap Mode (or is
blocked again in Escape Mode). An Event therefore has a
duration that can range from very short to very long.
Shutter Open Signal :
Signal transmitted from the LV5 to the camera which
commands the camera shutter to open.
Shutter Close Signal :
Signal transmitted from the LV5 to the camera which
commands the camera shutter to close ONLY when the camera
is in Bulb or Burst mode. If the camera is not in Bulb or
Burst mode, Shutter Close Signal will not affect the
shutter duration of the camera.
Delay :
An image is not taken immediately but after a set Delay
ti me. Set a Delay time when you want to capture a moment
later than the Event actually happens.
Freeze :
After an Event has been detected, the LV5 can ignore
furtherEventsforaspeciedamountoftime.Set a Freeze
time if you want to avoid further images to be taken after a
principle event occurred. Freeze can be achieved in LV5 by:
1. Shutter Pause: In Single Shot, LV5 will send shutter
open and close signal at a length according to the
Freeze value selected by user. No new events can trigger
LV5 during the Freeze period.
8.1
Basic
Concepts