User Manual

26
1. All V6 II transceivers must be set to the
same channel.
2. Assign RX units to Group A, B, C, or D by
pressing one of the group buttons. Each
RX can only be assigned to ONE group.
The LED of the selected group will turn
on.
3. Command the TX to f ire any combination
of groups by pressing the group
button(s). You can f ire any combination
of A, B, C, and D groups. The LED of the
activated group(s) will turn on.
4. To change the power level of a specif ic
group, press and hold an activated group
b ut t o n. B r ie  y p r e s s i n g t h e g r o u p
button again will de-select the group.
5. Pressing the group button(s) of activated
groups again on the V6 II TX will turn
off the group(s). The V6 II RX units that
have been set to the off group(s) will
not f ire.
6. The V6 II will memorize the group
selection in both TX and RX when it is
switched off. N e x t ti m e y o u s w it c h o n
the V6 II it will start up with the saved
setting.