User Manual

32
Notes:
1. If you would like to command an on-
c a m e r a  a s h, c o n n ec t y o u r  a s h t o t h e
V6 I I a n d s w it c h o n y o u r  a s h. T he n
switch on the V6 II while half-pressing
the camera shutter. The V6 II will
d et e ct t h e c a m e r a a n d  a s h s y st e m s at
the same time.
2. The auto-detect of the camera system
can be used to cross-check the
alignment of the hot shoe contacts.
Only properly connected cameras will be
detected by the V6 II.
Alternatively, photographers who mainly
work on one camera system may choose it from
the menu:
1. Switch on the V6 II in TX mode.
2. Press
, and turn the selection dial to
<CAMERA & FLASH SETUP>. Press
.
3. Press
, and turn the selection dial to
<CAMERA SYSTEM>. Press
.
4. Turn the selection dial until the LCD
shows your camera system (e.g.,
<PENTAX>). Press
.
10.2
Manual
Selection