User Manual

35
a n att a c h e d  a s h d u r i n g st a r t u p. T h e L C D
display will show the auto-detected ash
system at the top right-hand corner.
4. The V6 II will memorize the detected ash
s y st e m u nti l t h e n ex t d et e c tio n t a ke s
place.
If you wish to obtain more accurate output
that is f ine-tuned for your specif ic ash
units, choose the model-specif ic ash
prof iles (see Section 11.2) or customize the
e x i sti n g  a s h p r of i le s (s e e S e c ti o n 11.3).
Choose the appropriate ash prof ile from the
pre-installed prof ile list for each V6 II RX
a s si g n e d t o a  a s h.
1. Switch on the V6 II in RX mode.
2. Press
, and then turn the selection
dial to <FLASH SETUP>. Press
.
3. Turn the selection dial to <FLASH
SYSTEM>. Press
.
11.2
Choosing
a Flash
Profile