User Manual

36
4. Turn the selection dial until the LCD
s h o w s y o u r  a s h s y st e m (e.g., <C A N O N >).
Press
.
5. Turn the selection dial to <FLASH
PROFILE>. Press
.
6. Turn the selection dial until the LCD
s h o w s y o u r  a s h m o d el (e.g ., <5 80 E X*>).
Press
.
7. Connect the ash unit to the V6 II.
S w it c h y o u r  a s h t o T T L m o d e a n d y o u r
 a s h w i l l b e r e a d y f o r r e m o t e c o n t r ol.
The chosen ash prof ile will be applied
until you choose another ash prof ile.
If you wish to f ire and control an on-camera
 a s h v i a t h e V6 II T X, g o t o < CA M E R A & F L A S H
SETUP> and follow steps 3-7 above in the TX
m o de a n d c h o os e t h e a p p r o p r i a t e  a s h
prof ile for the on-camera ash.
If y o u r  a s h m o de l i s n ot i ncl u d e d i n t h e
pre-installed prof ile list but supports
digital TTL, apply the Auto Flash Prof ile in
the V6 II (see Section 11.1). To f ine tune
the power level commanded by the Auto Flash
Prof ile, you may customize it in the Cactus
Prof ile Editor available for a PC or Mac.
11.3
Cus-
tomizing
a Flash
Profile