User Manual

39
12. Flash Triggering
To command the ash units in different
groups to f ire:
1. Set the V6 II transceivers to the correct
mode (transmitter to “TX”, receiver to
“RX”). This will automatically power on
the transceivers (see Section 9.4).
2. Set both the TX and RX to the same
channel (see Section 9.5).
3. Assign RX unit(s) to A, B, C, or D group
and activate the group(s) on the TX (see
S e cti o n 9.6).
4. Connect the V6 II RX to portable ashes
or studio strobes.
5. On the TX, press
completely. The
status LED of both the TX and RX should
blink in green simultaneously. The
p o r t a b le  a s h e s or st u d i o s tr o b es w i l l
f ire at the same time.
6. Test f ire a particular group by
simultaneously pressing the group button
and
completely.
7. Attach the TX to the camera’s hot shoe.
If your camera does not have a hot shoe,
connect the TX to the camera using an
optional PC sync cable (CA-200).