User Manual

41
13. Remote Manual Power
Control and Zoom Control
Apart from ash triggering, the V6 II can
also command the manual power and manual
z o o m a n g l e of y o u r  a s h . O n e a c h R X, c h o o s e
the appropriate ash prof ile for each ash
to be connected. The V6 II TX will then be
able to command the ash to f ire from 1/128
to 1/1 full power, and at a zoom angle
between 16mm and 200mm.
To remotely control the power and zoom angle
of y o u r  a s h u n it s:
1. Connect the ash units to the V6 II.
2. Switch on the ash units in TTL mode.
Then switch on the V6 II in RX mode.
3. Apply the correct ash prof ile for each
V6 II (see Section 11).
4. If you want to command the ash to f ire
a b o v e t h e x- s y n c s p e e d, t u r n o n t h e H SS
or F P m o d e o n y o u r  a sh u n it s (s e e
S e cti o n 14.1).
V6 II offers two power def initions for users
to command the ashes’ power in the most
convenient way.