User Manual

48
1/8 power.
To change the V6 II system to the absolute
power mode:
1. Switch on the off-camera V6 II in RX
mode. Choose the correct ash prof iles
for each of the V6 II RX.
2. Switch on the V6 II that you would like
to be the commander in TX mode. Make
sure it is on the same channel as the RX
units.
3. Press
. Turn the selection dial to
<POWER SETUP>. Press
. Turn the
selection dial to <POWER MODE> and press
. Turn the selection dial to <ABSOLUTE
(SETUP)> and press
to conf irm.
4. The V6 II TX will then collect the ash
prof iles from the V6 II RX units and set
up the absolute power level scheme. Once
the setup is f inished, the LCD display
will return to the main screen again and
show the absolute light intensity of the
four groups.
5. Adjust the power level as you do in
relative power mode (see Section 13.1).
Each f igure before decimal place
represents 1 EV and the smaller f igure
thereafter 1/10 EV.