User Manual

50
The control panel of the V6 II TX offers
three EV step options: 1/10 EV, 1/3 EV, and
1/2 EV. The conf iguration applies to both
relative and absolute power modes.
To adjust the EV step:
1. Switch on the V6 II in TX mode.
2. Press
. Turn the selection dial to
<POWER SETUP> and press
. Turn the
selection dial to <EV STEP> and press
3. Turn the dial to the desired increment
level (1/10, 1/3, or 1/2). Press
to
conf ir m.
Notes:
1. The selected EV step will be memorized
upon switching off and will be applied
when switching on again.
2. In the quick power adjustment mode
(see Section 13.1.3), the conf igured EV
step will be replaced by the 1EV step
cha n g es.
At the Lo Power level, the relative power
output of a ash triggered by the V6 II
is roughly equal to 1/256. The difference
between 1/128 and 1/256 power outputs may
13.3
EV Step
13.4
Lo Power
.