User Manual

62
1. Connect the V6 II RX to your camera using
an appropriate shutter release cable.
2. Set both the V6 II TX and RX to the same
channel. On the V6 II TX, activate the
group assigned to the V6 II RX.
3. Half-press
on the TX to test the
auto focus. The status LED on both the
TX and RX will turn ORANGE to indicate
auto focus. Press
completely on the
TX for shutter release. The status LED
on both transceivers will turn GREEN to
indicate shutter release.
1. Set the camera to Bulb.
2. Press completely and hold
on the
V6 II TX. The status LED on the V6 II TX
and V6 II RX will turn GREEN at f irst and
go off after approximately 2 seconds.
The LCD display will show <BULB MODE ON>.
3. Release
on the V6 II TX. The
camera’s shutter is now in a continuous
open state.
4. To close the camera’s shutter, press
completely and release
on the V6 II
TX again. The green status LED on both
the TX and RX will blink simultaneously.
15.2
Bulb
Mode