Operation Manual

4. Fitting and Changing the Gas Cylinder

• Before connecting the appliance to a gas cylinder, ensure that the rubber seal on the Regulator is in position and in good condition.

• Carry out this check each time you  t the appliance to a gas cylinder.

• Blow out any dust from the cylinder opening to prevent possible blockage of the jet.

• Ensure that the appliance valves are in the off position by turning the knobs fully clockwise to their stop.

• Ensure that the gas cylinder is  tted or changed in a well-ventilated location, preferably outdoors, away from any source of

ignition, such as naked  ames and away from other people.

• Make sure that the gas cylinder is kept upright at all times, connect to the cylinder by screwing on hand tight until fully

engaged.

• Ensure that a complete gas seal has been made (check for the smell of gas around the connection joint). If there is a leak on

your appliance (smell of gas), take it outside immediately into a well-ventilated  ame free location where the leak may be detected

and stopped. To check for leaks on your appliance, do it outside using warm soapy water only, which is applied to the joints and

connections of the appliance. A formation of bubbles will indicate the gas leak. Do not check for leaks with a naked  ame.

• If you cannot rectify the gas leak do not use the appliance, contact your local CADAC stockist for assistance.

• CADAC gas cylinder valves must only be repaired by an authorised CADAC service centre or dealer.

• When changing a gas cylinder  rstly close the appliance control knobs and then the cylinder valve, making sure the  ame is

extinguished, unscrew the regulator. Re- t the regulator to a full cylinder following the same precautions as described above.

Product Code: 202M0-10

Lid

Pot Stand

Burner

Control Knob

503-0617 LEV7 (202M0) 2 Cook Classic - User Manual (EU & SA).indd 4 02/10/2017 11:58:14