User Manual

*
Please visit the Warranty section of the Unox Web site (www.unox.com) for further details
AFTER-SALES ASSISTANCE
In case of any malfunctions, disconnect the appliance from its power and water supply. Consult the solutions proposed in the table.
If the solution is not listed in the table, contact a technical service centre authorised
by UNOX. Provide the following information:
- the date of purchase;
- the appliance data on the serial plate;
- any warning messages that appear on the display.
Manufacturer's information:
UNOX SpA
Via Majorana, 22
35010 Cadoneghe (PD) Italy
Tel [phone] - Fax [phone]
[e-mail] www.unox.com
Malfunction Possible cause Possible solution Solution
The oven is completely
switched off.
- No mains power.
- Appliance out of order.
Make sure the appliance is
connected to the electricity
mains.
Contact the Customer
Assistance Service.
No steam is produced inside
the oven cavity.
- Water inlet closed.
- Appliance plumbed into the
water mains or the tank
incorrectly.
- No water in the tank (if
water is taken from the
tank).
- Water supply filter clogged
with impurities.
- Open water inlet.
- Make sure the appliance is
plumbed into the water
mains or the tank correctly.
- Fill the tank with water.
- Clean the filter.
After the time has been set
and the "
START/STOP" button
pressed, the oven does not
start.
Door open or not shut
properly.
Make sure the door is shut.
Water escapes from the seal
when the door is shut.
- Seal dirty.
- Seal damaged.
- The handle mechanism is
loose.
- Clean the seal using a damp
cloth.
- Contact a specialised
technician to request
repairs.
17
INT:
Made by: UNOX S.p.A. Via Majorana 22, 35010 Cadoneghe - Padova (ITALY)
3902067143 3902067143
MOD. 1
S/N
06-2017BakerLux
TM
GROSS WEIGHT: 62 kg NET WEIGHT: 50 kg
XEFT-04EU-xx
Pe: 6,3 kW 220-240V 1N˜ 220-240V 3˜/380-415V 3N˜50/60 Hz 1 50-600 kPa IP X3
LI2293A0
-
Sub jec
t t
o