Installation manual

GE Security
g
[*]-[9]-[3] SET KEYPAD OPTIONS
1. Enter [*]-[9]-[3] The LCD screen will prompt for a code.
2. Enter [program code]
The LCD will now prompt you through the options
listed in the following chart. The current state of the
option will be shown in the lower right corner of the
display. Press [*] to exit the current state without
any changes. Otherwise, follow the directions on
the bottom line to select the desired option. When
finished, press [*] to move to the next option.
OPT KEYPAD FEATURES
1
CASE TAMPER ON?
Tamper switch of keypad housing active
2
SILENT KEYPAD?
Enable silent keypad option. If this is on, silent keypad is enabled for
entry/exit delay and chime.
3
DING-DONG CHIME?
Enable ding-dong sound for chime. If this is off, the chime will be a single
tone.
4
5 SEC. SILENCE?
Enable keypress silence option. Silences the pulsing keypad sounder for 5
seconds when a key is pressed.
5
ARMED ZONE INFO?
Enable armed status suppression. If this is on, the keypad will not display
faulted or bypassed zones when the system is armed.
6
BEEP ON PANICS?
Enable panic, fire, medical beep tone. Will sound a short beep to verify that
the keypress has been accepted.
7
DISABLE SERVICE?
Suppresses the “Service” Message. This will not allow the “Service”
message to be displayed for any reason. If there is a system malfunction
(trouble), pressing [*]-[2] will still display the “Service” menu.
8
MASTER KEYPAD?
Enable multi-partition mode.
9
CUSTOM MESSAGE?
Enable custom message display.
10
CLOCK?
Enable clock display.
11
CUSTOM MSG. LOCK?
Enable custom message lock. Prevents the custom message from being
overwritten during keypad copy.
12
SELECT AN OPTION
1234 - - - -
NX-4-EUR Installation manual Page 17 08/09/04