Installation manual

GE Security
g
AUXILIARY OUTPUT EVENT SELECTION
DATA EVENT DATA EVENT
09 Burglary alarm 289 Expander trouble
19 Fire alarm 29 Dynamic battery test time
29 24 hour alarm 30 Open period
39 Trouble alarm 31 Closed period
4 Tamper alarm 32 Listen-in
5 Yelping siren 33 Line seizure
6 Steady siren 34 Reserved
7 Any siren 35 Fail to communicate
8 Any bypass 36 Telephone line fault
9 AC fail 37 Program mode
10 Low battery 38 Download in process
119 Duress 39 Reserved
129 Aux 1 keypad (fire alarm) 40
Short circuit (overcurrent on 12
Vdc)
139 Aux 2 keypad (medical alarm) 41 Box tamper
149 Panic keypad 42 Siren tamper
15 Keypad tamper 43 Any open
169 Autotest 44 Any short
17 Alarm memory 45
Any fault (open/short on non-fire
zone)
18 Entry 469 Any alarm
19 Exit 47 Beeping keypad
20 Entry or exit
48♦9
Code entry (see note below)
21 Armed state
49♣9
Key FOB function 1
22 Disarmed state
50♣9
Key FOB function 2
23 Ready 51 Always ON
24 Not ready 52 Autoarm warning time
25 Fire 53 Any siren when in away mode
26 Fire trouble
27 Chime
54
Progress of entry/exit (follows
keypad buzzer)
Note :
♦
When event 48 is programmed, it is possible to program a user code authorisation
to select the output(s), which a particular code will activate. When LED 8 is on for
an authorisation, then LED’s -24 will correspond to the code that activates outputs
1 - 2 respectively. (See “Programming the LED Keypads”)
♣
Events 49 and 50 require one or more of the following to operate: wireless
receivers or cardreaders.
9
If set to follow condition, these events will be 1 second.
NX-4-EUR Installation manual Page 51 08/09/04