Installation manual

Glossary
NX-8E Control Panel Installation Manual 105
Manual test
If programmed, the NX-8E performs a bell and/or communicator
test when *, 4, 4 is entered while the system is in the disarmed
state. (Location 37)
Night mode
This mode applies to NX-1208E/1248E keypads. In this mode,
the control panel bypasses all zones that have the entry guard
feature enabled. (Locations 23 and 110 tp 169)
Onboard zone disable
For a completely wireless alarm system, the eight zones on the
NX-8E panel can be disabled. (Location 37)
Program code
The default for the go to program code is 9, 7, 1, 3 when using a
four-digit code. If a six-digit code is used, the default is 9, 7, 1,
3, 0. 0. The program code can be used as an arm/disarm code.
If used as an arm/disarm code, and open/close reports are sent,
the user code is 255. (Location 43)
Quick arm feature
The NX-8E has a one-button quick arm feature which is used to
arm the system by pressing the Exit key or the Stay key on the
keypad. User code is 98, if closing reports are sent. (Location
23)
Recent closing
If enabled, the NX-8E sends a recent closing report to the
central station if an alarm occurs within 2 minutes after the
panel is armed. The system always reports user 1. (Location
23)
Re-exit
The NX-8E has the ability to restart the exit delay for a quick
exit without disarming the system by pressing the Exit key while
the system is armed. (Location 23)
Shutdown
When enabled, the keypads turn off all LEDs except the Power
LED and does not accept keypresses (can only be activated via
download). (Location 21)
Siren blast for arming
If programmed, the NX-8E gives a 1-second siren blast when
the panel is armed at the end of the exit delay or when the
central station receiver acknowledges the closing report. If also
gives one blast for remote (keyswitch) arming and two blasts for
remote disarming. Four blasts at disarm means that there has
been an alarm. (Location 37)
Siren supervision
The NX-8E has a siren supervision circuit that constantly
monitors the siren and reports if the siren wires are cut.
(Location 37)
Silent exit option
The exit delay is silenced by pressing *, Exit before arming the
control panel or when using the reexit feature. (Location 37)
Start/end programming and
end downloading
A report is sent when local programming starts and ends. A
report is also sent when a download session ends. (Location
37)