Installation manual

Chapter 2: Reporting codes
42 NX-8E Control Panel Installation Manual
Location 55 - Days of week each partition will automatically arm
Location 55 has eight segments of feature selection data. Use this location to
select which days each partition (1 to 8) will autoarm. If a zone is faulted when
the panel tries to autoarm, the zone bypasses. Default is 0 for each segment.
For each segment (1 to 8), select the following:
1 = Sunday
2 = Monday
3 = Tuesday
4 = Wednesday
5 = Thursday
6 = Friday
7 = Saturday
8 = Disable 45 minute
retry timer
Locations 56 to 83 - 4+2 format communicator codes
Use Locations 46 to 83 only when reporting events to a pager or using a slow
format such as 4+2. When using Contact ID or SIA, you do not need to program
these locations. There are eight segments of numerical data for each location
and the default for all segments is 0.
The digit programmed in each of the segments in these locations is sent as the
upper hex digit in place of the alarm event code. The zone ID or user ID is
reported as the lower hex digit (1-F). For example, if the zone ID or user ID is 3,
the 4+2 lower digit is 3. If the segment is left as 0 and the feature is enabled, the
NX-8E reports A.