Operating Instructions and Installation Instructions

AQUOS - IBIS - IDRON

15.1 DAILY OR WEEKLY CLEANING PERFORMED BY THE USER

15.2 BEFORE EACH START-UP

Clean the ash and any deposits in the brazier that could clog the air passage holes.

If the pellets in the hopper nish, unburned pellets may accumulate in the brazier. Always empty the residue in

the brazier before startingup.

REMEMBER THAT ONLY A CORRECTLY POSITIONED AND CLEAN BRAZIER CAN GUARANTEE

START-UP AND OPTIMAL OPERATION OF YOUR PELLET PRODUCT.

For the brazier to be cleaned properly, remove it from its housing completely and thoroughly clean all the holes

and the grate on the bottom.

If good quality pellets are used, you will normally only need to use a brush to restore the optimal operating

conditions of the component.

15.3 CLEANING THE GLASS

It is recommended to clean the ceramic glass with a dry brush, or if it is very dirty, spray a little specic detergent

and clean with a cloth.

ATTENTION!

Do not use abrasive products and do not spray the glass spray cleaner on the painted parts

or the door gaskets (ceramic bre cord).

15.4 CLEAN THE EXCHANGER AND THE UNDERGRATE SPACE EVERY 2/3 DAYS.

Cleaning the exchanger and the undergrate space is a simple operation but very important for always

maintaining performance as declared.

Therefore we recommend cleaning the internal exchanger every 2-3 days, performing these simple operations

in sequence:

• Activate the “CLEANING” function – when the stove is switched of press - menu “3”, select“Settings”, with

the <> arrows “2-4” select “Cleaning”, conrm with “Menu” “3”, activate cleaning “ON” by pressing the +-

keys “5-6”. This procedure activates the smoke extraction fan on maximum power to expel the soot that is

dislodged when the exchanger is cleaned.

• Clean the pipe unit – Using the hook provided, shake the rods located under the top (A to Fig. 39 page

46 and Fig. 40 page 46) vigorously 5-6 times. This operation removes the soot that has deposited on the

exchanger smoke ducts during normal stove operation.

• Clean the smoke conveyor compartment see Fig. 39 page 46 for AQUOS 15-22-22 H2O / IBIS 15-22-22 H2O

/ IDRON 15-22-22 H2O models - Stoves are tted with a removable ash pan “C” designed to collect any soot

and ash build-up.

• Clean the smoke conveyor compartment see Fig. 40 page 46 for IBIS 11 / IDRON 11 models - Open the

door, insert the hook onto the rod of the scraper B, shake it vigorously 5-6 times along the entire length.

Remove the hook and reposition the rod B fully in its seat. This will help the fan expel any soot build-up which

may have fallen during the previous pipe unit cleaning process. (After shaking the rods A, always shake the

scraper B too).

• Disable the “CLEANING” function - this function is automatically disabled after two minutes. If one needs to

stop this function in advance press the “Esc” key.

If these cleaning operations are not performed every 2-3 days, the stove could go into

alarm conditions due to ash clogging after several hours of operation.