Operating Instructions and Installation Instructions
29
AQUOS - IBIS - IDRON
EN
DO NOT EXPECT HEATING EFFICIENCY IMMEDIATELY!!!
10.2 OPENING/CLOSING THE DOOR
ATTENTION!
The door must be closed properly for the boiler to work correctly.
Use suitable protective clothing (such as gloves) to open the boiler door.
10.3 SETTINGS TO BE CARRIED OUT BEFORE THE INITIAL START-UP
Once the power cable is connected in the rear part of the stove, turn the switch, also placed at the rear, to
position (I). To switch the stove on or off press key 1 on the control panel.
Fig. 27 - Key and display
10.4 LOADING THE PELLETS
Fuel is loaded from the upper part of the stove by opening the door. Pour the pellets into the hopper.
To ease the procedure carry out the operation in two steps:
Pour half of the contents into the hopper and wait for the fuel to settle on the bottom.
Then complete the operation by pouring in the rest.
Never remove the protection grille from within the hopper. When loading prevent the pellet
bag from coming into contact with hot surfaces.
No other type of fuel other then pellets, in compliance with above-mentioned specications,
is to be inserted into the hopper.
Store the back-up fuel at a suitable safety distance.
Do not pour the pellets directly onto the brazier but only into the hopper.
Most of the stove surfaces are very hot (door, handle, glass, smoke outlet pipes, hopper
door, etc.). It is therefore recommended to avoid coming into contact with these parts
without adequate protective clothing.
11
MENU ITEMS
11.1 CONTROL PANEL DISPLAY
Menu items.