Operating Instructions and Installation Instructions

32
AQUOS - IBIS - IDRON
EN
• Press “menu” to conrm.
• Enter the minutes with the + - keys.
• Press “menu” to conrm and “esc” to exit.
h - Pump On T
To select the Pump On T function act as follows:
• Press the “menu” button.
• Scroll to “Settings” using the arrows
• Press “menu” to conrm.
• Scroll to “Pump On T” using the arrows.
• Press “menu” to conrm.
• Modify the °C with the + - keys.
• Press “menu” to conrm and “esc” to exit
i - Auxiliary boiler
One must install an additional module (optional) to enable start-up of an auxiliary boiler in the event the boiler
is switched off or in alarm conditions. By default this function is deactivated, if needed activate it to access the
settings menu.
l - Pellet Recipe
To change the recipe act as follows:
• Press the “menu” button.
• Scroll to “Settings” using the arrows
• Press “menu” to conrm.
• Scroll to “Pellet recipe” using the arrows.
• Press “menu” to conrm.
• Modify the % with the + - keys.
• Press “menu” to conrm and “esc” to exit
m - Smoke rpm % ventilation
To change the parameter act as follows:
• Press the “menu” button.
• Scroll to “Settings” using the arrows
• Press “menu” to conrm.
• Scroll to “Smoke rpm variation” using the arrows.
• Press “menu” to conrm.
• Modify the % with the + - keys.
• Press “menu” to conrm and “esc” to exit
n - Maximum power
To change the power act as follows:
• Press the “menu” button.
• Scroll to “Settings” using the arrows
• Press “menu” to conrm.
• Scroll to “Maximum power” using the arrows.
• Press “menu” to conrm.
• Change the power from 01 to 05 with the + - keys
• Press “menu” to conrm and “esc” to exit
o - Components test
To activate the “Components test” function (only when the boiler is switched off) act as follows:
• Press the “menu” button.
• Scroll to “Settings” using the arrows
• Press “menu” to conrm.
• Scroll to “Components test” using the arrows.
• Press “menu” to conrm.
• Select the test to be performed with the + - keys
• Press “menu” to conrm and “esc” to exit
p - Chimney sweep function
To activate the “Chimney sweep” function act as follows:
• Press the “menu” button.
• Scroll to “Settings” using the arrows
• Press “menu” to conrm.
• Scroll to the “Chimney sweep” function using the arrows.