Operating Instructions and Installation Instructions

AQUOS - IBIS - IDRON

Fig. 39 - Cleaning the internal pipe unit using scrapers (Aquos

15-22-22 H2O / Ibis 15-22-22 H2O / Idron 15-22-22 H2O)

Fig. 40 - Cleaning the lower drawer (Ibis 11 / Idron 11)

15.5 PERIODIC CLEANING PERFORMED BY A QUALIFIED TECHNICIAN

15.6 CLEANING THE HEAT EXCHANGER

Half-way through the winter season, but especially at the end of it, the compartment through which the exhaust

smoke passes will need to be cleaned. This cleaning process is mandatory in order to facilitate the general

removal of all combustion residue, before it becomes very difcult to remove it due to the humidity compacting

it over time.

ATTENTION: For your safety, the frequency with which the exhaust smoke system is cleaned

depends on the intensity of use of the stove.

15.7 CLEANING THE EXCHANGER AND PIPE UNIT (AQUOS 15-22-22 H2O / IBIS 15-22-22 H2O

/ IDRON 15-22-22 H2O)

15.8 CLEANING THE UPPER COMPARTMENT

When the stove is cold, remove the top, remove the ceramics/sides, by loosening the relative fastening screws

before removing the drivers “B” and then remove the boiler cover “C” At this point, remove the four turbulators

“D” and using a rigid rod or a bottle brush, clean the internal pipe unit and the turbulators, removing all of the

accumulated ash.

Check the cover gasket and replace it if necessary.

ATTENTION: It is advisable to carry out the cleaning of the upper exchanger at the end of

the season and possibly by an authorised technician in order to replace the gasket that is

below plug “C”. (Fig. 41 page 47).