ZRS C5 1-Ohm Mono Load Woofer Wiring Remote turn on from radio, do not wire woofers to this terminal! = 1-Ohm Load. 2-Ohm Final Woofer Load Or 2-Ohm Final Woofer Load DVC 2-Ohm Wired in Parallel to 1-Ohm To amp + 1-Ohm Mono Load Woofer Wiring To amp - Remote turn on from radio, do not wire woofers to this terminal! DVC 4-Ohm Wired in Parallel to 2-Ohm DVC 4-Ohm Wired in Parallel to 2-Ohm = 1-Ohm Load.
ZRS C6 / C7 Daisy Chaining ZRS Amplifiers DAISY CHAINING AMPLIFIERS, HOW TO SET SWITCHES, INPUTS AND REMOTE CONTROL. 1-Ohm Final Impedance Load! RCA Headunit signal to Master Amp only! No RCA Cables to be attached to Slave Amplifier. Amp #1 in Master Mode Fully adjusted Signal is transferred from Master to Slave Amp Amp #2 in Slave Mode via RCA Cable.
ZRS C5 / C6 / C7 CONTROLS RCA PREAMP OUTPUT INPUT GAIN CONTROL The preamp output is a full range signal mixed from both input channels. Use this signal to feed a secondary full range amplifier in your system. ADJUSTABLE SUBSONIC FILTER WITH PHASE CONTROL The ZRS C5,6,7 feature a fully adjustable Subsonic Filter which can be set from 10Hz - 50Hz. This High Pass Filter is especially useful when tuning vented enclosures.