Installation Guide

Table Of Contents

Remove the rubber washer (B), ABS

mounting (C), and connector (D)

from the end of the stud.

I n s t a l l a t i o n i n s t r u c t i o n

U N I VE R S A L B AT H T U B S P O U T

UNIVERSAL

BATHTUB SPOUT

I n s t a l l a t i o n i n s t r u c t i o n

Installation instruction

PAGE 1
UNIVERSAL BATHTUB SPOUT Installation instruction A B C D U N I V E R S A L B A T H T U B S P O U T I I n s n s t a l l t a t i o n i a n s t r u c t i o n l l a t i o n Remove the rubber washer (B), ABS mounting (C), and connector (D) from the end of the stud.
PAGE 2
A Place the faucet assembly (A) through the selected hole in the sink or countertop. On the underside of the sink or countertop, slide the rubber washer (B) and ABS mounting (C) onto the stud. And tighten securely using your wrench. B C A Thread the quick connect adaptor (E) onto the end of the faucet assembly (A) stud, and tighten securely using a wrench. Water line from the filtration system by pushing the line into the connector (D).