Specification Sheet

ManualsBrandsCadet Heaters ManualsAccessoriesCadet Grille Kit for Cadet Energy Plus Heaters

EnErgy Plus

More comfort, less energy

• Now with even quieter operation

• Built-in digital thermostat and

large backlit display

• Control your comfort with simple

buttons and Night/Away settings

• Enjoy ultra-quiet operation of the

variable speed fan

• Keep the air circulating year-round

with the fan-only mode

• Install easily without damaging the

heater—smart sensor auto adjusts the

heater voltage to match your power

supply

• Tamperproof settings let you lock

in minimum and maximum

temperature points

• Easily replace Com-Pak series

heaters with the Energy Plus—

 ittsexistingCom-Pakwallcans

• Rest easy—includes high-

temperature safety shutoff feature

cadetheat.com

855.CADET.US

Vancouver, Washington

USA

The smart choice for your comfort and your wallet, the Energy

Plus uses up to 30% less energy than regular wall heaters.

Say goodbye to temperature swings—intelligent controls and

auto adjusting fan speed maintain room temperature within

one degree. And control your comfort with a simple, built-in,

backlit digital thermostat.

ARCHITECTURAL - ENGINEERING INFORMATION

Fan forced up ow electric air heaters are ETL listed, factory eld rated

for multi-watt (120V/208V/240V) installations, 1600 watts at 240 volt, 1500

watts at 208 volt and 1000 watts at 120 volt, and single-volt installations,

1600 watts at 240 volt, 1600 watts at 208 volt. The wall mounting can for this

heater is a 20-gauge sheet steel with six electrical knockouts and 22 cubic

inches for a wiring compartment, and nished with a powder coat paint

system. The proportional fan and heat operation automatically adjusts

fan speed and wattage output from 1600 watts to 200 watts (240v power)

depending on heat loss within the space. A two stage centrifugal blower

is driven by an impedance protected motor. The motor is totally isolated

from the heating chamber. Unit is equipped with a fan only mode for air

circulation. The air ow rate is 18 to 44 cfm. Element construction is a coiled

nichrome heating wire sealed in a steel sheath with steel ns brazed to the

sheath. Heating unit includes a 16-amp rating at 240V, high temperature

manual reset limit switch. Unit is protected from over-voltage use. Each

complete heater is of unitized construction, attaches to the wall can with a

single screw, and is self-contained and completely separate from the wall

mounting can. Metal grill is of one piece, 22-gauge steel construction,

and nished with a powder coat paint system. On board digital controller

minimizes energy use and optimizes comfort through independent regula-

tion of heating element and fan motor. The automatic regulation prevents

over-voltage, limits current in-rush, and provides motor soft-start. The con-

trols include a one-button set back operation that is adjustable for night or

away mode, and a maximum and minimum lock feature.

Summary of content (2 pages)

PAGE 1
Energy Plus More comfort, less energy The smart choice for your comfort and your wallet, the Energy Plus uses up to 30% less energy than regular wall heaters. Say goodbye to temperature swings—intelligent controls and auto adjusting fan speed maintain room temperature within one degree. And control your comfort with a simple, built-in, backlit digital thermostat.
PAGE 2
TECHNICAL INFORMATION UL safety standards require the heater to be placed a minimum distance of ¾ inches (1.9 cm) from adjacent surfaces and 4-1/2 inches (11.4 cm) from the floor. For optimal performance and extended heater life, place at a distance of 24 inches (61 cm) from the floor. ADA requirements are met if the heater is installed between 12-1/2 inches (31.8 cm) and 42 inches (1.1 m) from the floor. A 3-foot (91.