Installation Sheet

ManualsBrandsCadet Heaters ManualsWall HeatersCadet Com-Pak 5120 BTU Electric Wall Heater Assembly

INSTALLATION INSTRUCTIONS

KNOW YOUR VOLTAGE!

120 volt

single-pole breaker

240 volt

double-pole breaker

• Connecting a 120 volt heater to a 240 volt electrical supply will destroy the

heater and void your warranty! Connecting a 240 volt heater to a 120 volt

electrical supply will only give you one quarter of the heat output.

• Make sure the heater is the same voltage as the electrical supply wires you’re

using. The wire size must be correct for the voltage, the heater wattage and

the circuit breaker.

1. All electrical work and materials

must comply with the National

Electric Code (NEC), the Occu-

pational Safety and Health Act

(OSHA), and all state and local

codes.

2. Use copper conductors only.

3. DO NOT install the heater

directly above bathtub or sink.

DO NOT install in shower stall

area. Manufacturer recommends

a minimum 2 foot (61 cm) side

clearance.

4. Heater must be installed in a wall

can:

Model CS - wall can models CC

or CCSM

Model CST - wall can model CTC

5. DO NOT install the heater in a ﬂoor,

below a towel bar, behind a door,

or anywhere the air discharge may

be blocked in any manner.

6. A heater has hot and arcing or

sparking parts inside. Do not use

it in areas where gasoline, paint,

or ﬂammable vapors or liquids are

used or stored.

7. Connect grounding lead to ground-

ing screw provided. Keep all for-

eign objects out of heater.

8. CAUTION-High temperature, risk

of ﬁre, keep electrical cords, drap-

ery, furnishings, and other com-

bustibles at least 3 feet (0.9 m)

from the front of the heater and

away from the side.

PARTS OF YOUR HEATER

If you are uncomfortable working with electricity, running electrical supply

wire or installing a circuit breaker, please consult a licensed electrician.

• CHECK YOUR BREAKER! If you’re replacing an existing heater, check the

labels of the old heater and use the same voltage.

Unanswered questions? Call our technical support team in Vancouver,

Washington at 855.CADET.US.

built-in thermostat

(optional)

rating label

heater element

fan and

motor

high-temperature

safety shutoffs