Installation Guide

cadetheat.com Tel: 855.CADET.US PO Box 1675 Vancouver, WA 98668-1675
Benets You Can Depend On
SAVE THESE INSTRUCTIONS
CTT1 CTT2 Built-In Thermostat Kit
Installation Instructions
IMPORTANT
TOOLS
REQUIRED:
• Phillips
Screwdriver
• Wire Connectors
• Built-in temperature control for your Cadet
Com-Pak or Com-Pak Twin heater
• Easy to use adjustable dial
• Available in white or almond color to match
your heater
• Use with Cadet CS, C, CST and CT 120-,
208-, or 240-volt models
• Available in single pole (2 wires) or double
pole (4 wires), and tamper-proof
• 22 Amp
• Your CTT built-in thermostat is guaranteed
with a limited 1 year warranty
1. Read all instructions before installing or using
this thermostat.
2. High temperatures may be generated under
certain abnormal conditions. Do not partially or
fully cover or obstruct the front of this heater.
3. Do not operate any heater after it malfunctions.
Disconnect power at service panel and have
heater inspected by a qualied electrician before
reusing.
4. To disconnect heater, turn controls to off or
low, and turn off power to heater circuit at main
disconnect panel.
5. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening as this may
cause an electric shock or re, or damage the
heater.
6. To prevent a possible re, do not block air
intakes or exhaust in any manner.
7. A heater has hot and arcing or sparking parts
inside. Do not use it in areas where gasoline,
paint, or ammable vapors or liquids are used or
stored.
8. Do not use outdoors.
When using electrical appliances, basic precautions should always be followed to reduce the risk of re,
electric shock, and injury to persons, including the following:
Single Pole Thermostat Models:
CTT1W
CTT1A
CTTP (tamper-proof model)
http://www.cadetheat.com/products/wall-heaters/com-pak
Double Pole Thermostat Models:
CTT2W
CTT2A
CTT2P (tamper-proof model)
Page 1