Installation Guide

&+,$$,"'&&+,*-,"'&+
%('*,&,&'*%,"'&
1'-*-&'%'*,$/'*#"& /",!$,*"$(($"&+-&$,''$$'/,!+ -"$"&+
'*'&',!.,!&++*1)-"(%&,'&+-$,$"&+$,*""&

-*&,!$,*"$('/*',,!$,*"$(&$'*"*-",*#*'*-+'0&$'#'*,
,!(&$'*''*,'(*.&,+'%'&*'%,-*&"& '&('/*/!"$1'-*/'*#"& '&,!!,*
"$-*,''+''-$*+-$,"&+*"'-+$,*"$+!'#-*&+'*('++"$,!

1. Read and understand heater instructions found in the model SL Owner’s Guide.
2. Remove wall can knockout closest to the supply wires. Right side only.
3. Mount the wall can securely to the wall, paying attention to minimum heater clearances.
4. Feed the supply wires through the knockout using an appropriate strain relief connector (not provided).
5. Feed the supply wires into the heater wall can clamps located at back of wall can.
6. Wire the heater according to the installation instructions included with the heater and connect ground to grounding lug.
7. Screw the heater to the wall can using the four screws provided with heater.
*"$$
,*++%$1
$$&-*'-&,

• Phillips Screwdriver • Appropriate Wire Nuts • Appropriate Fasteners • Strain Relief Connector

cadetheat.com Tel: [phone] P.O. Box 1675 Vancouver, WA 98668-1675
©2014 Cadet Printed in U.S.A. 12/14 #720061
The SLCS Surface Mount Adapter
Surface Mount Metal Adapter for
Model SL Heater Installation Guide
h
ttp://www.cadetheat.com/products/wall-heaters/SL