Installation Guide

WARNING
Turn the electrical power off at the electrical panel
board (circuit breaker or fuse box) and lock or tag the
panel board door to prevent someone from turning on
power while you are working on the heater. Failure to
do so could result in serious electrical shock, burns,
or possible death.
1. Read all instructions before using this heater.
2. Read all information labels. Verify that the electrical
supply wires are the same voltage as the heater.
3. All electrical work and materials must comply with the
National Electric Code (NEC), the Occupational Safety
and Health Act (OSHA), and all state and local codes.
4. Connect the grounding screw provided in the wall can
to the supply ground wire.
5. If you need to install a new circuit or need additional
wiring information, consult a qualified electrician.
6. Protect electrical supply from kinks, sharp objects, oil,
grease, hot surfaces or chemicals.
7. WARNING
Overheating or fire may occur. DO NOT install the
heater in a floor, ceiling, behind doors, or outdoors.
8. WARNING
Fire or explosion may occur. Heater has hot and arcing or
sparking parts inside. Do not install heater in any area where
combustible vapors, gases, liquids, or excessive lint or dust
are present.
9. WARNING
Burn Hazard. This heater is hot when in use. To avoid burns,
do not let bare skin touch hot surfaces. Use extreme caution
when any heater is used by or near children or invalids and
whenever the heater is left operating unattended.
10. WARNING
Risk of Electrical Shock. Keep all foreign objects out of heater.
Do not operate after heater malfunctions or has been dropped
or damaged in any manner.
11. WARNING
Risk of Fire. Do not block heater. Heater must be kept clear
of all obstructions: a minimum of 3 feet in front, 6 inches above
and on both sides. Heater must be kept clean of excessive
lint, dirt and debris. (See Maintenance Instructions).
12. Use this heater only as described in this manual. Any other
use not recommended by the manufacturer may cause fire,
electrical shock, or injury to persons.
O WNER’ S GUI DE
The SL Series
MODELS:
SL152TW
SL192TW
SL252TW
SL302TW
SL101TW
SL151TW
Features & Benefits
•
Commercial grade high
temperature manual reset
•
Grill design provides even
air distribution
•
Quiet operation
•
Built-in double pole thermostat
•
Powder coat paint process
eliminates sharp metal edges
•
Two year extended warranty
16¾”
42.54cm
12
7
/8”
32.7cm
1
14½”
36.83cm
4
10.16cm
New installation
requires wall can
(sold separately):
SLC Recess Mount
SLC-S Surface Mount
SAVE THESE INSTRUCTIONS
IMPORTANT INSTRUCTIONS
www.cadetco.com Tel: [phone] P.O. Box 1675 Vancouver, WA 98668-1675
TOOLS REQUIRED:
Phillips Screwdriver
Straight Screwdriver
Wire Strippers
Utility Knife
(4) 1
1
/2“ Wood Screws
Insulated Wire Connectors
(1) Strain Relief Connector
11
1
/8”
28.26cm
9
7
/8”
25.08cm