Instructions / Assembly

ManualsBrandsCadet ManualsHeating, Venting & CoolingDouble-Pole 22 Amp 120-Volt/240-Volt Wall-Mount Mechanical Non-programmable Thermostat in White

OWNER’S GUIDE

T521 T522

WALL THERMOSTAT

http://cadetheat.com/install/t5

For how-to videos or more information, please visit:

ESPAÑOL ver la guía del propietario en cadetheat.com/espanol/t5

cadetheat.com

855.CADET.US

Vancouver, Washington

tested to UL standards

Thank you for your purchase! Question or problem? Let us solve

it with a single phone call, email or online chat! We’ll save you a

trip back to the store!

Phone: 855.CADET.US (855.223.3887)

email: customerservice@cadetheat.com

Live chat: cadetheat.com (contact us)

Cadet Customer Service

Summary of content (4 pages)

PAGE 1
OWNER’S GUIDE T521 T522 WALL THERMOSTAT For how-to videos or more information, please visit: http://cadetheat.com/install/t5 ESPAÑOL ver la guía del propietario en cadetheat.com/espanol/t5 Thank you for your purchase! Question or problem? Let us solve it with a single phone call, email or online chat! We’ll save you a trip back to the store! Cadet Customer Service Phone: 855.CADET.US (855.223.3887) email: customerservice@cadetheat.com Live chat: cadetheat.com (contact us) cadetheat.com 855.CADET.
PAGE 2
IMPORTANT INSTRUCTIONS When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Read all instructions before 4. To disconnect thermostat turn off installing or using this thermostat. power to heater circuit at main 2. Use this thermostat only as disconnect panel. described in this manual. Any 5. Do not operate any thermostat other use not recommended by after it malfunctions.
PAGE 3
INSTALLATION INSTRUCTIONS 1. WARNING: All electrical work and materials must comply with the National Electric Code (NEC), the Occupational Safety and Health Act (OSHA), and all state and local codes. 2. WARNING: Make sure all wire connections to the thermostat are correct and tight to prevent electrical shorts. Use appropriate wire to meet NEC and local codes for rated power consumption. 3. Use copper conductors only. 4. Turn off power to heater at main disconnect panel. 5.
PAGE 4
INSTALLATION INSTRUCTIONS DOUBLE POLE (4-WIRE) - 120 VOLT B FROM POWER SUPPLY A. Connect the two black thermo- B stat wires to the two loose heater wires. B. Connect the two supply wires to the two red thermostat wires. C. Connect the copper ground supply wire to the copper wire going to the heater. C TO HEATER A A Proceed to OPERATING INSTRUCTIONS. OPERATING INSTRUCTIONS Make sure all wires are properly connected and installation is complete before you turn on the heater.