Full Product Manual

2
SAVE THESE INSTRUCTIONS
IMPORTANT INSTRUCTIONS
KNOW YOUR VOLTAGE!
1. Read all instructions before
installing or using this heater.
2. This heater is hot when in use.
To avoid burns, do not let bare
skin touch hot surfaces. Keep
combustible materials, such as
furniture, pillows, bedding, papers,
clothes, etc. and curtains at least
3 feet (0.9 meters) from the front
of the heater and keep them away
from the sides.
3. Extreme caution is necessary
when any heater is used by or near
children or invalids and whenever
the heater is left operating and
unattended.
4. Do not operate any heater after
it malfunctions. Disconnect
power at service panel and have
heater inspected by a reputable
electrician before reusing.
5. Do not use outdoors.
6.
To disconnect heater, turn
control(s) to o󰀨, and turn o󰀨
power to heater circuit at main
disconnect panel.
7. Do not insert or allow foreign
objects to enter any ventilation
or exhaust opening as this may
cause an electric shock or fire, or
damage the heater.
8. To prevent a possible fire, do not
block air intakes or exhaust in any
manner.
9. A heater has hot and arcing or
sparking parts inside. Do not use
it in areas where gasoline, paint,
or flammable vapors or liquids are
used or stored.
10. Use this heater only as described
in this manual. Any other use
not recommended by the
manufacturer may cause fire,
electric shock, or injury to persons.
11. This heater must be installed in a
fixed, permanent location.
When using electrical appliances, basic precautions should always be
followed to reduce the risk of fire, electric shock, and injury to persons, including
the following:
120 volt
single-pole breaker
240 volt
double-pole breaker
WARNING: Connecting a heater to a voltage higher than what’s listed on its
rating label will destroy the heater and could start a fire. A heater will not heat
properly when connected to a voltage lower than what’s listed on its rating
label.
If you are uncomfortable working with electricity, running electrical supply wire
or installing a circuit breaker, please consult a licensed electrician. Make sure
power to the heater is turned o󰀨 at the main disconnect panel whenever doing
any work on a heater. Serious injury or electrocution can result from electric
shock.
• CHECK YOUR BREAKER! If you’re replacing an existing heater, check the
labels of the old heater and use the same voltage.
Unanswered questions? Call our technical support
888-346-7539.