Full Product Manual

3
INSTALLATION INSTRUCTIONS
TOOLS REQUIRED
1. All electrical work and materials must
comply with the National Electric
Code (NEC), the Occupational
Safety and Health Act (OSHA), and
all state and local codes. Canadian
installations must comply with the
Canadian Electrical Code (CEC)
and provincial codes.
2. Use copper conductors only.
3. DO NOT install the heater directly
above bathtub or sink. DO NOT
install in shower stall area.
Manufacturer recommends a
minimum 2 foot (61 cm) clearance
to prevent contact with water.
4. DO NOT install the heater in a
floor, in a ceiling, below a towel
bar, behind a door, or anywhere
the air discharge may be blocked
in any manner.
5. To reduce the risk of fire, do not
store or use gasoline or other
flammable vapors and liquids in the
vicinity of the heater.
6.
Connect grounding lead to
grounding screw provided. Keep all
foreign objects out of heater.
7.
CAUTION – High temperature,
risk of fire, keep electrical cords,
drapery, furnishings and other
combustibles at least 3 feet (0.9
m) from the front of the heater and
away from the side and rear.
Tape Measure
Straight and Phillips
Screwdrivers
1½" Wood Screws
Wire Strippers Wire Connectors
½" Cable Clamp
Connector
Volt Meter
Drill and Drill Bits
A multi-purpose tool or saw to cut toe kick area.
Z
I
R
C
O
N
®
®
Z
I
R
C
O
N
®
®
Z
I
R
C
O
N
®®
Z
I
R
C
O
N
®
®
Z
I
R
C
O
N
®®
Z
I
R
C
O
N
®
®
Hammer
Z
I
R
C
O
N
®
®
Z
I
R
C
O
N
®®
Z
I
R
C
O
N
®®
PARTS OF YOUR HEATER
built-in thermostat (optional)
heater
element
fan and motor
(under top lid)
high-temperature safety
shuto󰀨 (under top lid)