Full Product Manual

6
Set wattage
STEP 4
Install Grille
STEP 5
Reinstall heater lid and attach using four screws provided. Slide heater into opening. Fasten heater to
cabinet with screws (not provided) going through the lower holes located on the flanges. See Figure 3.
Fasten grille to heater with screws provided going through the upper holes located on the flanges.
Turn power on at the main disconnect panel.
Proceed to OPERATING INSTRUCTIONS.
The heater is shipped ready for 240 volt, 1800 watts. If 900 watts is required, disconnect the yellow
terminal from the heating element spade marked D in the wiring diagram. Wrap the disconnected
terminal with electrical tape. See Figure 5.
For 120 volt, 1350 watts, disconnect the yellow terminal from the heating element spade marked D in
the wiring diagram. Wrap the disconnected terminal with electrical tape. See Figure 4.
For 120 volt, 900 watts, disconnect the yellow terminal from the heating element spade marked D and
B in the wiring diagram. The red wire assembly can be removed and discarded.
For 120 volt, 450 watts, complete the step above for 900 watts, then disconnect the yellow terminal
from the heating element spade marked C in the wiring diagram. Wrap the disconnected terminal with
electrical tape.
INSTALLATION INSTRUCTIONS