User's Manual
10
3.3InstallationInstructions
Warning
All analogue or digital equipment connected to the CADI
SMN890S should be in accordance with IEC standards (IEC
60960 for information technology equipment safety and IEC
60601-1 for medical electrical equipment safety). All equipment
should be connected in accordance with IEC 60601-1-1 standards.
The personnel in charge of connecting peripheral equipment are
responsible for making sure that these standards are followed. In
doubt, contact manufacturer.
Warning
The Device should be position when it is disconnected from direct
plug-in power adaptor to avoid failure of device operation
3.4Cleaning
Warning
Turn off CADI SMN-890S SMB-800 and unplug the cord from the
wall outlet before cleaning the CADI SMN-890S.
Clean the CADI SMN-890S regularly. In places with poor
environmental conditions, cleaning should be more frequent.
Consult hospitals before cleaning for any regulations.
Use clean soft cloth or cotton sponge dampened with cleaning
solutions to wipe the CADI SMN-890S exterior. Use the following
recommended solutions:
Diluted soap solution;
Diluted Ammonia, Sodium hypochlorite (bleaching powder) or
diluted formaldehyde (35-37%);
Alcohol or Glutaraldehyde.
Note
Sodium hypochlorite with concentration range 500 ppm (Diluted bleaching
powder for family use 1:100) to 500 ppm (Diluted bleaching powder for
family use 1:10) is very effective. The ppm depends by the amount of stain