User's Manual

7.1.2 Gypsum Ceiling Board

1. In general for gypsum ceiling board, single mounting plate is

used. The mounting plate should be affixed using proper wall plug

for gypsum ceiling board.

2. Once the mounting plate is fixed to the ceiling, the SMN-890

should be pushed and then it is slid into the plate to place to mount

the reader properly.

3. A hole should be made in the ceiling for the LAN cable to

drop out from the ceiling into the Receiver. This cable will be

interfaced to the Active RFID Receiver using a standard TCP/IP

port available on the back of the Receiver using a standard RJ-45

connector. It is as shown on figure 12 below.

Figure 12: SMN-890 mounted on gypsum ceiling board using single

mounting plate and 4 wall plugs

Wall plug

Screw