User's Manual

7.2 Wall Mounted

1. Typically, a wall mounted Active RFID Receiver requires

three holes on the wall surface to mount the base of the wall mount

bracket by using wall plug type 10mm with 14-18 screw size.

Figure 13: Wall mounting bracket

2. The length of the screw depends on the strength of the wall

that can hold the Active RFID Receiver that weights approximately

600 grams.

3. A ceiling-to-wall conduit fitting should be laid until the base

of the wall mounted bracket to install LAN cable and from there it

should be linked up to back of the Receiver using a standard RJ-45

connector. It is as shown on figure 14 below.