Owners Manual

p““
4. With the coolant
surge tank
pressure cap
off,
start the engine
and let it run until
you can feel the
upper radiator
hose getting hot.
Watch out for
the
engine fans.
By this time, the coolant
level inside the coolant surge tank may be lower.
If the level is lower, add more of the proper mix to the coolant surge tank
until the level reaches about 2 1/2 inches (60 mm) below the base of the
filler neck.
r
5. Then replace the
pressure cap. Be
sure the arrows
on
the pressure cap
line up like this.
7
Start the engine and allow it to warm up. If the “ENGINE COOLANT
LOW” message does not appear on the Driver Information Center,
coolant is at
the proper fill level. If an “ENGINE COOLANT LOW”
message does appear, repeat steps 1 to 3 or see your dealer.
228