Instruction manual

Chrysler (Chrysler, Jeep, Dodge, Plym-
outh, Eagle)
Make sure the iPod2car adaptor is compatible with your vehicle, Check for “Disc ^” printed on
preset button “1”. If you see it, it means that your radio can control the iPod2car adaptor.
Before connecting any cables to the iPod2car you must set the dip switch to the correct
position. If you set the dip-switches after you have connected cables to the box, you
must disconnect and reconnect them for the iPod to operate.
.
Remove the radio to see which cable fi ts your vehicle, and then refer to settings below.
Do not force cables in.
:
DIP SWITCHES MUST BE SET BEFORE YOU PLUG IN THE iPod2car !!!
VEHICLE INSTALLATION
1
2
3
4
5
6
7
8
on
off
off
on
off
off
off
on
SETTINGS FOR
“CHRYSLER OLD
DIN” CABLE
1
2
3
4
5
6
7
8
off
off
off
on
off
off
off
on
SETTINGS FOR
“CHRYSLER NEW
DIN” AND “10 PIN
CABLES
Use the PXHCH2 cable with vehicles 1999-2001.
Use the PXHCH3cable with vehicles 2002-2004.
-Connects behind the radio
Use the PXHCH1 cable with vehicles 1995-1999/2000.
-Connects behind the radio
OPERATION FOR
ALL
Switch to the iPod2car adaptor by pressing the “CD” or
“MODE” button. To change tracks simply press “Seek <” or
“Seek >”
11