Owners Manual
RCL:
Press
this
button briefly to recall the station being
played or
the
clock display. To change what is normally
shown on
the
display (station or time), press the button
until you see the &splay you want. Then, hold the button
until the display flashes.
If
you press
the
button when the
ignition is
off,
the clock will show for a few seconds.
AM-FM:
Press this button to get AM, FMl or FM2.
The display shows your selection. You may also press
AM-FM
to switch between the radio and tape when a
tape is in the player.
TUNE:
Press this knob lightly
so
it extends. Turn it to
choose radio stations. Push the knob back in when
you're not using it.
SEEK:
Press the up or down arrow to go to the
next higher or lower station. The sound will be muted
while seeking.
PUSHBUTTONS:
The five numbered pushbuttons let
you return to your favorite stations. You can set up to
15 stations (five AM, five FM1 and five
FM2).
1.
Press AM-FM to select the band.
2.
Find the station you want by using TUNE or SEEK.
3.
Press TONE to select the setting you prefer.
4.
Press and hold one of the five numbered buttons.
5.
The sound will mute. When it returns, release
the button. Whenever you press that numbered
button, the station you set will return and the
TONE you selected will be automatically selected
for that button.
TONE:
This feature allows you to choose preset treble
and bass equalization settings designed for jazz, vocal,
pop, rock and classical stations. JAZZ will appear on the
display when you first press TONE. Each time you press
it, another setting will appear on the display. Press
it
again after classic appears, and MANUAL will appear.
Tone control will return to the TREB and BASS knobs.
Also, if you use the TREB and BASS knobs, control
will return to them and MANUAL will appear.
SCAN:
Press and release this button
to
listen to stations
for a few seconds. The radio will go to a station, stop for
a few seconds, then go on to the next station. Press
SCAN again to stop scanning. The sound will be muted
while scanning, and SCAN will appear on the display.
If
you press SCAN for more than two seconds, the radio
will change to PSCAN mode. PSCAN will appear on
the display.
PSCAN:
Press SCAN for more than two seconds for
PSCAN to appear
on
the display. The radio will go to the
first preset station, stop for a few seconds, then go to the
next preset station. Press SCAN again to stop scanning.
3-9