Owners Manual

lhrn
SignaVMultifunction
Lever
’hrn and Lane Change
Signals
To
signal a
turn,
move the lever
all
the way up or down.
The
lever returns automatically when the
turn
is complete.
An arrow on the instrument
panel will flash in the
direction of the turn or
lane change.
If the turn signal is left on, a warning chime will sound
and the
DIC
will display
TURN
SIGNAL
ON
(after
driving about
a
mile) to remind
you
to turn it
off.
Arrows that flash rapidly when signaling for
a
turn or
lane change may be caused by a burned out signal bulb.
Other drivers won’t see the turn signal.
Replace burned-out bulbs to help avoid possible
accidents. Check the fuse (see “Fuses and Circuit
Breakers” in the Index) and for burned-out bulbs if the
arrow fails to work when signaling
a
turn.
r
Beam
Changer
Headlamp
High/Low
Raise or lower the lever until the arrow starts to flash to
signal a lane change. Hold it there until
the
lane change
is complete. The lever returns when it’s released.
Pull the turn signal lever all
the way toward
you
and
then release it to change the
headlamps from low beam
to high or from high beam
to low. This light on the
instrument panel will be on,
indicating high beam usage.
2-37