Owners Manual
Manual
Operation
RECIRCULATION:
Press this button to limit the
amount of fresh air entering your vehicle. This is helpful
when you are trying to cool the air quickly or limit odors
entering your vehicle. In the AUTO mode, the system
will use recirculation
as
necessary to cool the air.
Pressing the recirculation button will change the
operation to
a
manual mode and the air will recirculate
non-stop. Press this button again to turn
off
the
recirculation feature.
If you notice the windows fogging, press the
recirculation button to exit the recirculation mode.
OFF:
Press this button to turn the system off. Fresh air
will continue to flow through the vehicle, and the
system will try to maintain the previously set
temperature. The outside temperature will show
in
the
display when the system is off.
DEFOG:
Press this button to divide the air between the
windshield and the heater outlets. This is useful when
fog appears on the windshield or side glass due to
sudden rain or snowy conditions.
AUTOECON:
Press
this
button to switch between
AUTO
and
ECON.
The
ECON
setting attempts to keep air
at a selected temperature, however, it does not remove
humidity from the
air.
Use this setting in cold or cool
weather to save fuel. The AUTO setting is used when it’s
warm
outside and you need to cool the air
in
order to
maintain a selected temperature and blower speed.
#
FAN SPEEDS:
Press the button with the fan
symbol on it until AUTO is displayed
on
the screen.
At this setting, the fan speed
is
automatically controlled.
If it is cold outside, the blower may not run in the
maximum high fan speed right away. The system checks
the temperature
of
the engine coolant to assure it is
warm enough to provide heat. When the engine coolant
is
warm,
the controller allows the fan to gradually
increase to a higher speed. This prevents cold air from
blowing into the passenger compartment. If you want
the blower fan at a high speed, press the up arrow button
until you see HI on the display. If you want the fan
speed to be automatic, but you like the fan speed to be
higher than the AUTO setting, press the fan symbol
button until
HI
AUTO
is shown on the display. If you
want the blower
fan
at a low speed, press the down
arrow button until
LO
is shown on the display. If you
want the fan speed to run lower than the
AUTO
setting, press the button until AUTO
LO
is shown
on the display.
9
DEFROST
Press this button to quickly remove
fog or frost from the windshield. This setting sends most
of the airflow to the windshield with only a small
amount to the floor outlets.
AI