Owners Manual

When cleaning the cassette tape player with the
recommended non-abrasive cleaning cassette, it is
possible that the cassette may eject, because the cut
tape detection feature on your radio may recognize it as
a broken tape, in error.
To
prevent the cleaning
cassette from being ejected, use the following steps:
1.
Turn the ignition on.
2. Turn the radio
off.
3. Press and hold the TAPE DISC button for five
seconds. READY will appear on the display and
the cassette symbol will flash for five seconds.
4.
Insert the scrubbing action cleaning cassette.
5. Eject the cleaning cassette after the manufacturer’s
recommended cleaning time.
When the cleaning cassette has been ejected, the cut
tape detection feature is active again.
You may also choose
a
non-scrubbing action, wet-type
cleaner which uses a cassette with a fabric belt to
clean the tape head. This type of cleaning cassette will
not eject on its own. A non-scrubbing action cleaner
may not clean as thoroughly as the scrubbing type
cleaner. The use
of
a non-scrubbing action, dry-type
cleaning cassette is not recommended.
After you clean the player, press and hold the eject
button for five seconds to reset the CLEAN indicator.
The radio will display
---
or CLEANED to show the
indicator was reset.
Cassettes are subject to wear and the sound quality
may degrade over time. Always make sure the cassette
tape
is
in good condition before you have your tape
player serviced.
Care
of
Your CDs
and
DVDs
Handle discs carefully. Store them in their original cases
or other protective cases and away from direct sunlight
and dust. If the surface
of
a
disc is soiled, dampen
a clean, soft cloth in a mild, neutral detergent solution
and clean it, wiping from the center
to
the edge.
Be sure never to touch the side without writing when
handling discs. Pick
up
discs by grasping the outer
edges or the edge of the hole and the outer edge.
Care
of
Your
CD Changer
The use
of
CD lens cleaner discs is not advised, due to
the risk of contaminating the lens of the CD optics
with lubricants internal to the CD mechanism.
3-95