Specifications

Put some cardboard down on the floor and have some rags on hand as you will inevitably spill /
splash some oil. Place a drain pan directly under the drain and fill plugs.
Clean the areas around both plugs. Using a 3/8” drive swivel arm socket wrench and 10mm
allen socket of about 1 – ¾” total length (as shown), loosen and remove the fill plug. (Always
remove the fill plug before removing the drain plug) There are different ways of accessing this
plug but the photos show one method that seems to work well and is easy. Note in the photos
that the socket wrench handle extends down through the middle of the aluminum cross
member. Some oil may start to drip out. If the plug is very tight, use a piece of pipe over your