Owners Manual

Black plate (32,1)
Cadillac SRX Owner Manual - 2013 - CRC - 11/9/12
10-32 Vehicle Care
10. Reinstall the taillamp cover by
snapping it into place.
11. Push the push pin to secure
the taillamp cover.
Back-Up Lamps
To replace one of these bulbs:
1. Open the liftgate. See Liftgate
on page 2‑13.
2. Remove the push pin (1) on the
taillamp cover (2).
3. Remove the taillamp cover from
the lamp assembly by pulling
rearward from the top to
unfasten from the snap tabs.
4. Remove the two screws from the
taillamp assembly.
5. Pull the taillamp assembly
straight back to remove.
6. Disconnect the wiring harness
connector from the back-up bulb/
socket assembly.
7. Turn the back-up bulb socket
counterclockwise to remove it
from the taillamp assembly.
8. Install a new bulb/socket
assembly into the taillamp
assembly, and turn the bulb/
socket clockwise until it clicks.
9. Reinstall the taillamp assembly
and tighten the screws.