Owner's Manual

Cadillac ELR Owner Manual (GMNA-Localizing-U.S/Canada-9087644) -
2016 - crc - 4/20/15
Keys, Doors, and Windows 35
5. Wait for 10 minutes until the
DIC displays PRESS ENGINE
START BUTTON TO LEARN,
then press POWER
O.
The DIC reads REMOTE
LEARN PENDING,
PLEASE WAIT.
6. Repeat Step 5 two additional
times. After the third time all
previously known transmitters
will no longer work with the
vehicle. Remaining transmitters
can be relearned during the
next steps. The DIC display
should now show READY FOR
REMOTE #1.
7. Remove the rubber liner to
access the pocket. Place the
new transmitter, button side
down, on the indent in the
center console storage area.
8. Press POWER
O. When the
transmitter is learned, the DIC
display will show that it is ready
to program the new transmitter.
9. Remove the transmitter from
the transmitter pocket and
press
Q or K on the
transmitter.
10. To program additional
transmitters, repeat Steps 7–9.
11. When all additional transmitters
are programmed, press and
hold POWER
O for
approximately 12 seconds to
exit programming mode.
Starting the Vehicle with a Low
Transmitter Battery
When you try to start the vehicle,
if the transmitter battery is weak,
or if there is interference with the
signal, the DIC may display NO
REMOTE DETECTED or NO
REMOTE KEY WAS DETECTED
PLACE KEY IN TRANSMITTER
POCKET THEN START YOUR
VEHICLE. See Key and Lock
Messages 0 137.
To start the vehicle:
1. Open the center console
storage area and the
storage tray.
2. Place the transmitter, button
side down, into the transmitter
indent.
3. With the vehicle in P (Park) or
N (Neutral), press the brake
pedal and POWER
O.