User's Manual
Table Of Contents
- Overview
- 2. Getting started
- 2.1. Software User interface: installation
- 2.2. Launching the Software User interface
- 2.3. Connection configuration
- 2.4. Logical source selection
- 2.5. Detecting test tags with the RF field
- 2.6. Readout of one tag’s memory
- 2.7. Temperature monitoring with the semipassive tag
- 2.8. Creating the Log file
- 2.9. RF Field test
- 2.10. Quit CAEN RFID Demo program
- 2.11. ISO18000-6B protocol tags operations
- 2.12. EPC1.19 protocol tags operations
- 3. Firmware upgrade
- 4. RFID Test program
- 5. RFID CsDemo program
Document type: Title: Revision date: Revision:
User's Manual (MUT) RFID Software User Interface 18/02/2006 1
Fig. 2.8 – Change Event mode message
Fig. 2.9 – Asynchronous Acquisition configuration
If you wish to make a Timed Acquisition in READCYCLE MODE:
− choose “Timer” as trigger type in the drop down menu of the Asynchronous
Configuration which is started as Asynchronous Acquisition is selected.
− set the timer period in “Delay time” field
− set the notification on Local or Remote host: in the latter case you have to enter the
host IP address
− “Start” acquisition
The notification takes place on the RFID Server window, which is shown either on the
Local host or on the Remote one:
Fig. 2.10 – RFID Server
If you wish to make a I/O Timed-out Acquisition in READCYCLE MODE:
− choose the General Purpose Input you wish to use as trigger type in the drop down
menu of the Asynchronous Configuration.
− set the time out delay in “Delay time” field
NPO: Filename: Number of pages: Page:
00117/03:Demox.MUTx/01 RFIDDEMO_REV1.DOC 27 11