User's Manual
Table Of Contents
- Overview
- 2. Getting started
- 2.1. Software User interface: installation
- 2.2. Launching the Software User interface
- 2.3. Connection configuration
- 2.4. Logical source selection
- 2.5. Detecting test tags with the RF field
- 2.6. Readout of one tag’s memory
- 2.7. Temperature monitoring with the semipassive tag
- 2.8. Creating the Log file
- 2.9. RF Field test
- 2.10. Quit CAEN RFID Demo program
- 2.11. ISO18000-6B protocol tags operations
- 2.12. EPC1.19 protocol tags operations
- 3. Firmware upgrade
- 4. RFID Test program
- 5. RFID CsDemo program
Document type: Title: Revision date: Revision:
User's Manual (MUT) RFID Software User Interface 18/02/2006 1
2.3.3. Input output management
This function allows to handle the reader general purpose inputs/outputs;
click on
configuration > I/O Management
The following pop-up window will open:
By checking the Output boxes, the relevant signal will be driven high. The Input status is
also monitored: red = active, green = idle.
Fig. 2.5 – Reader Network configuration
2.4. Logical source selection
Click on
configuration > configure logical source
The following pop-up window will open:
Fig. 2.6 – Logical source selection and test
the antenna(s) status is checked:
BAD (antenna not connected) = RED
POOR (antenna with faulty operation) = YELLOW
GOOD (antenna ok) = GREEN
Then choose the antenna(s) you wish to use.
Finally it is necessary to set the thresholds:
Observed:
READCYCLE MODE (see §
2.5): the number of subsequent times a tag must appear in
an acquisition before it shifts from “glimpsed” to “observed”
NPO: Filename: Number of pages: Page:
00117/03:Demox.MUTx/01 RFIDDEMO_REV1.DOC 27 9