User's Manual
Table Of Contents
- 1. Introduction
- 2. Mod. A528 Technical Specifications
- 2.1. Mod. A528 Technical Specifications Table
- 2.2. External connections
- 2.2.1. A528 Main connector pinout
- 2.2.2. A528 MAIN connector electrical characteristics
- 2.2.3. Power supply connection
- 2.2.4. General purpose I/O connections
- 2.2.5. External reset
- 2.2.6. UART connection
- 2.2.7. A528 recovery
- 2.2.8. A528 USB connector pinout
- 2.2.9. USB connector pinout electrical characteristics
- 2.2.10. Antenna port specifications
- 2.3. Reader – Tag link profiles
- 2.4. Host communication interfaces
- 2.5. A528 Firmware Upgrade
Federal Communications Commission (FCC) Notice (Preliminary)
This device was tested and found to comply with the limits set forth in Part 15 of the FCC Rules. Operation
is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received including interference that may cause undesired operation.
These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment.
This device generates, uses, and can radiate radio frequency energy. If not installed and used in
accordance with the instruction manual, the product may cause harmful interference to radio
communications. Operation of this product in a residential area is likely to cause harmful interference, in
which case, the user is required to correct the interference at their own expense. The authority to operate
this product is conditioned by the requirements that no modifications be made to the equipment unless the
changes or modifications are expressly approved by CAEN RFID.
© CAEN RFID srl – 2008
Disclaimer
No part of this manual may be reproduced in any form or by any means, electronic, mechanical,
recording, or otherwise, without the prior written permission of CAEN RFID.
Preliminary Product Information: This document contains information for a new product. CAEN RFID
reserves the right to modify this product without notice.
“Preliminary” product information describes products that are ready for production, but for which full characterization
data is not yet available. CAEN RFID believes that the information contained in this document is accurate and reliable.
However, the information is subject to change without notice and is provided “AS IS” without warranty of any kind
(Express or implied). You are advised to obtain the latest version of relevant information to verify, before placing orders,
that information being relied on is current and complete. All products are sold subject to the terms and conditions of sale
supplied at the time of order acknowledgement, including those pertaining to warranty, patent infringement, and
limitation of liability. No responsibility is assumed by CAEN RFID for the use of this information, including use of this
information as the basis for manufacture or sale of any items, or for infringement of patents or other rights of third
parties.
NPO: Filename: Number of pages: Page:
00101/07:A528X.MUTx/02 A528_REV02.DOC 19 2