User's Manual

CAEN UHF RFID Readers Communication Protocol – Technical Information Manual
16
Code
Description
Comp.
0x7F
KillTag: permits to kill a EPC Class 1 Gen 1 tag.
Parameters:
SourceName: [in] the name of the source.
TagIDLen: [in] the ID length of the tag.
TagID: [in] the ID of the tag.
EPCPWD: [in] the EPC password.
ResultCode: [out] the result code.
A928EU
A948EU
0x80
RFOnOff: permits to start/stop the generation of a continuous wave. Used only for test
and measurements purposes.
Parameters:
RFOnOff: [in] = 0  stop; != 0  start
ResultCode: [out] the result code.
A928EU
A948EU
A828EU
A828AEU
A829EU
A949EU
A528
R1230CB
R1260I
R1260U
0x81
GetBitRate: permits to get the BitRate in use.
Parameters:
BitRate: [out] the BitRate in.
ResultCode: [out] the result code.
A928EU
A948EU
A828EU
A828AEU
A829EU
A949EU
A528
R1230CB
R1260I
R1260U
0x82
BlockWriteTag: permits to write data to the tag memory. This function uses the
ISO18000-6b Write4Byte command to speed up the writing of large amount of data at
one time.
Parameters:
SourceName: [in] the name of the source to use.
TagIDLen: [in] the ID length of the tag.
TagID: [in] the ID of the tag.
TagAddress: [in] the address where to write the data.
Length: [in] the number of bytes to write.
TagValue: [in] the data to write to the tag memory.
ResultCode: [out] the result code.
A928EU
A948EU
A828EU
A828AEU
A829EU
A949EU
0x83
SetRS232: permits to modify the settings of the serial port.
Parameters:
Baudrate: [in] the baud rate value.
Databits: [in] the data bits setting.
Stopbits: [in] the stop bits setting.
Parity: [in] the parity setting.
Flowctrl: [in] the flow control setting.
ResultCode: [out] the result code.
A928EU
A948EU
A828EU
A828AEU
A829EU
A949EU
A528
R1230CB
R1260I
R1260U
0x84
SetDateTime: permits to modify date and time.
Parameters:
Datetime: [in] the date and time to set up.
ResultCode: [out] the result code.
A928EU
A948EU
A828EU
A828AEU
A829EU
A949EU