Manualshelf

User's Manual

ManualsBrandsCAEN RFID ManualsElectronicsR1170IUNFHP - qIDmini Keyfob UHF NF RFID Reader
12345678910
INTRODUCTION - qIDminiNF Technical Information Manual 8
Charging
The qIDminiNF R1170INF is supplied with an USB cable and a power supply for charging (see § Accessories page 9).
When you put the reader in charge, the display lights up and shows the blinking charge indicator. The fixed indication
“charge 100%” informs you that the charging is complete.
Warning: EMPTY BATTERY CONDITION
In case that the battery is fully discharged, the display may not turn on when the charger is connected. In this case you
have to leave the reader connected to the charger for at least 5 minutes, then disconnect the USB cable, perform the
reset procedure (see § RESET THE qIDminiNF READER page 40), switch off the reader by pressing the power button and
then connect the USB cable again.
USB connector
A micro USB Type B socket connector is located in the bottom side of qIDminiNF R1170INF and can be used to connect
the reader to an USB host port or to an AC/DC battery charger.
Y