Use and Care / Installation Manual

ManualsBrandsCafe Appliances ManualsCookingCafe™ 36" Smart Dual-Fuel Commercial-Style Range with 6 Burners (Natural Gas)

Table Of Contents

31-2000815v05_EN

36” and 48” Dual Fuel Professional Ranges

C2Y366, C2Y486

31-2000815 Rev. 0 11-20 GEA

Questions? Visit cafeappliances.com.

Installation Instructions

Contents

Safety Information ..................................2

Design Information

Product Dimensions and Clearances ................4

Installation Information

High Altitude Kit ................................7

Materials Provided ..............................7

Materials Required (not provided) ..................7

Tools Required .................................7

Installation

Remove Packaging ............................8

Move the Range Indoors ........................9

Install Anti-Tip Device .........................10

Converting to Propane (LP) Gas or Converting

Back to Natural Gas From Propane (LP) .........11

Gas Supply ..................................11

Electrical Connections .........................12

4-Wire Power Cord Installation ..................12

3-Wire Power Cord Installation ..................13

Roll Range into Position ........................13

Level the Range ..............................14

Replace Oven Door(s) .........................14

Check Burners ...............................15

Check Surface Burners ........................15

Finalize Installation ............................15

When All Hookups Are Completed ...............15

Accessory Installation

Toekick .....................................16

UX12BS36PSS, UX12BS48PSS Accessory Installation

Optional Accessories—12” High Backsplash

Tools and Materials Required ...................17

Install 12” Backsplash .........................17

UXADBS36PSS, UXADBS48PSS Accessory Installation

Accessories—30” To 36” Adjustable Backsplash

Tools and Materials Required ...................18

Install the Wall Support Panels ..................19

Install Cover Panels ...........................19

English • Français • Español

Summary of content (20 pages)

PAGE 1
TM Installation Instructions 36” and 48” Dual Fuel Professional Ranges C2Y366, C2Y486 Contents Safety Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Design Information Product Dimensions and Clearances. . . . . . . . . . . . . . . . 4 Installation Information High Altitude Kit. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Materials Provided. . . . . . . . . . . .
PAGE 2
Safety Information Have a question or need assistance with your appliance? Try the Café website 24 hours a day, any day of the year! You can also shop for more great Café products and take advantage of all our on-line support services designed for your convenience. In the US: cafeappliances.com. (In Canada, cafeappliances.ca.) IN THE COMMONWEALTH OF MASSACHUSETTS ■ This product must be installed by a licensed plumber or gas fitter. ■A flexible gas connector, when used, must not exceed 5 feet.
PAGE 3
Safety Information BEFORE YOU BEGIN Read these instructions completely and carefully. IMPORTANT ■ — Save these instructions for local inspector’s use. IMPORTANT ■ — Observe all governing codes and ordinances. IMPORTANT ■ — Remove all packing material and literature from oven before connecting gas and electrical supply to range.
PAGE 4
Design Information PRODUCT DIMENSIONS AND CLEARANCES 48” Range Models 47-7/8” Width 1” Countertop to Cooking Surface Universal Utility Locations 8” 29 3/8” Depth to Front of Bullnose Gas/ Electric 6-1/2” 35-1/4” to 36-3/4” Height to trim. Trim to be flush or higher than countertop. 3-1/4” to 4-3/4” Toekick/ leg Height 12” Minimum to Adjacent Wall 48” Minimum to Combustible hood require 48” minimum to combustibles.
PAGE 5
Design Information PRODUCT DIMENSIONS AND CLEARANCES 36” Range Models 1” 35-7/8” Width Universal Utility Locations Countertop to Cooking Surface 4-5/8” 29 3/8” Depth to Front of Bullnose 35-1/4” to 36-3/4” Height to trim. Trim to be flush or higher than countertop.
PAGE 6
Design Information PRODUCT DIMENSIONS AND CLEARANCES 48” and 36” Range Models 10-1/2” 29-3/8” To Front Edge 13/16” 30-36” Optional Backsplash Accessories 12” (36” models only) 7” Control Panel Height 1” 35-1/4” to 36-3/4” 28-1/2” To Front of Door 12” Min. to combustibles or 0” to a non-combustible material above the cooking surface ** 31-1/8” To Front of Handle 48-1/4” With Oven Door Open ** As defined in the National Fuel Gas Code (ANSI Z223.1/CSA B149.1, Current Edition).
PAGE 7
Installation Information INSTALLATION AT HIGH ALTITUDE TOOLS REQUIRED Over 6000ft, product configured for natural gas or propane requires installation of kit (WB28X39728 for natural gas and WB28X39729 for propane gas). Follow the instructions included with the kit.
PAGE 8
Installation 1 REMOVE PACKAGING CAUTION Stand clear. The ends of the cut metal banding may snap toward you. ■ Cut the metal banding. Lift the carton straight up. ■ Open oven door(s) and remove packaging. Remove shelf holding broiler pan, tape, literature package, shelf lubricant and probe. CAUTION Doors and passageways leading to the ■ Locate the two runner strips from the top of the packaging. These strips will be used to protect the kitchen floor during installation.
PAGE 9
Installation 2 MOVE THE RANGE INDOORS 1. Tilt the range forward on the skid. 4. Attach the hand-truck straps around the unit. IMPORTANT: Place the hand-truck straps below the oven door handles. To avoid damaging the side panels, place a pad between the hand-truck and the range. 5. Tilt the range to lower the hand-truck wheels off the skid. Hand-Truck Straps Below Oven Door Handles Toekick 2. Lift the toekick out of the foam base. Toekick 3.
PAGE 10
Installation 3 INSTALL ANTI-TIP DEVICE WARNING • • • • • Tip-Over Hazard A child or adult can tip the range and be killed. Install the anti-tip bracket to the wall or floor. Engage the range to the anti-tip bracket by sliding the range back such that the foot is engaged. Re-engage the anti-tip bracket if the range is moved. Failure to do so can result in death or serious burns to children or adults.
PAGE 11
Installation 4 CONVERTING TO PROPANE (LP) GAS OR CONVERTING BACK TO NATURAL GAS FROM PROPANE (LP) This range leaves the factory set for use with natural gas. If you want to convert to propane (LP) gas, the conversion must be performed by a qualified propane (LP) gas installer. The conversion orifices Cooktop Regulator and instructions can be found on back of the range. Keep these instructions and all orifices in case you want to convert back to natural gas.
PAGE 12
Installation 6 ELECTRICAL CONNECTIONS WARNING This appliance must be properly grounded. WARNING All new constructions, mobile homes, recreational vehicles and installations where local codes do not allow grounding through neutral, require a 4-conductor UL-listed range cord. WARNING To prevent fire or shock, do not use an extension cord with this appliance. 6 ELECTRICAL CONNECTIONS (Cont.) A range cord rated at 40 amps with 125/250 minimum volt range is required.
PAGE 13
Installation 8 3-WIRE POWER CORD 7 4-WIRE POWER CORD INSTALLATION (Cont.) INSTALLATION (Cont.) ■ Insert the 3 terminal screws (removed earlier) through each power cord terminal ring and into the lower terminals of the terminal block. Be certain that the center wire (white/neutral) is connected to the center lower position of the terminal block. Tighten screws securely into the terminal block. Before Ground Strap DO NOT REMOVE THE GROUND STRAP CONNECTION.
PAGE 14
Installation 10 LEVEL THE RANGE (cont.) 10 LEVEL THE RANGE WARNING The range must be level and be supported by the legs—not the wheels. The range could move if the wheels make contact with the floor. Be sure all legs make contact with the floor in any installation. ■ All legs must be leveled after the product is installed. ■C heck to be sure the adjoining cabinets/countertops are level, front to back and left to right across the opening of the range.
PAGE 15
Installation 12 CHECK BURNERS WARNING Fire or Explosion Hazard: Do not operate the burner without all burner parts in place. A. Burners - Place surface burners into corresponding positions on cooktop. B. Caps - Place caps on proper size burner. C. Grates - The left and right grates are interchangeable. Place the grates on the cooktop. FINALIZE INSTALLATION Place the burner grates over the burners. The grates should be seated and should not rock. The griddle is secured with screws.
PAGE 16
Accessory Installation TOEKICK (included) ■ Install the toekick after the range has been leveled. ■ Measure the distance between the floor and the bottom of range. ■ Loosen the two screws on each end. Adjust the toekick height by sliding the upper and lower pieces apart to 1/8” less than the measured height. ■ Secure the top and bottom sections by tightening the 2 screws on each end. ■ Push toekick against range leg until clip snaps to legs. NOTE: Be sure the toekick snaps securely to the leg.
PAGE 17
UX12BS36PSS, UX12BS48PSS Accessory Installation OPTIONAL ACCESSORIES—12” HIGH BACKSPLASH This kit provides for the installation of a 12” high backsplash for 36” Professional Ranges and Rangetops. TOOLS AND MATERIALS REQUIRED ■ Gloves to protect against sharp edges ■ T-15 and #2 Phillips screwdrivers ■ Drill with 3/32” and 9/64” bits ■ Safety glasses Wall Support Panel Cover Panel ■ Level This Kit Includes fastened to the wall. Failure to do so could result in damage or personal injury.
PAGE 18
UXADBS36PSS, UXADBS48PSS Accessory Installation ACCESSORIES—30” TO 36” ADJUSTABLE BACKSPLASH (not included) ■ This backsplash adjusts to fit the space between the top of the range and the bottom of the hood, from 30” Min. to 36” Max. height. INSTALL THE WALL SUPPORT PANELS ■ Maximum shelf load-bearing weight is 40 lbs. securely fastened to the wall. Failure to do so could result in damage or personal injury.
PAGE 19
UXADBS36PSS, UXADBS48PSS Accessory Installation ACCESSORIES—30” TO 36” ADJUSTABLE BACKSPLASH (not included) (Cont.) INSTALL COVER PANELS INSTALL COVER PANELS (cont.) See alternate method if side access is blocked. ALTERNATE METHOD: When side access is blocked ■ Hold the bottom cover over the bottom support while driving one screw (provided) into each side. ■ Install bottom cover over the bottom support while driving one screw into each side.
PAGE 20
NOTE: While performing installations described in this book, safety glasses or goggles should be worn. NOTE: Product improvement is a continuing endeavor at GE Appliances. Therefore, materials, appearance and specifications are subject to change without notice. 20 Printed in Mexico 31-2000815 Rev.