Use and Care / Installation Manual
Table Of Contents
31-2000814 Rev. 1 11
Installation
6
ELECTRICAL CONNECTIONS
WARNING
ShockHazard:Thisappliancemust
be properly grounded. Failure to do so can result in
electric shock.
ElectricalRequirements-120-volt,60Hertz,properly
grounded dedicated circuit protected by a 15-amp or
20-amp circuit breaker or time delay fuse.
NOTE:Useofautomatic,wireless,orwiredexternal
switchesthatshutoffpowertotheappliancearenot
recommended for this product.
Grounding
Thepowercordofthisapplianceisequippedwith
athree-prong(grounding)plugwhichplugsintoa
standardthree-pronggroundingwallreceptacleto
minimize the possibility of electric shock hazard from
this appliance.
Thecustomershouldhavethewallreceptacleand
circuit checked by a qualified electrician to make sure
the receptacle is properly grounded.
Whereastandardtwo-prongwallreceptacleis
encountered,itisthepersonalresponsibilityand
obligationofthecustomertohaveitreplacedwitha
properlygroundedthree-prongwallreceptacle.
DONOT,UNDERANYCIRCUMSTANCES,CUTOR
REMOVE THE THIRD (GROUND) PRONG FROM
THE POWER CORD. DO NOT USE AN ADAPTER.
DO NOT USE AN EXTENSION CORD.
Ground Fault Circuit Interrupters (GFCI’s) are not
required or recommended for gas range receptacles.
Performanceoftherangewillnotbeaffectedif
operated on a GFCI-protected circuit but occasional
nuisance tripping of the GFCI breaker is possible.
7
ROLL RANGE INTO POSITION
WARNING
The Anti-Tip Bracket must be
properly installed to prevent tipping of the range.
Failure to do so can cause serious damage or injury.
■Checktobesuretheappliancerunnersare
beneaththewheels.
■Therangeisshippedwiththewheelsinthedown
position.Carefullyrolltherangeintoposition,being
carefulnottoentangleorpinchthepowercordand
flexiblegastubing.
■Removetherunnersbeneaththerange.
Ensure proper
groundexists
before use
Be sure Anti-Tip
Bracket is engaged
withthebraceon
the range.